Daily 8 AM–8 PM

Carrollton, TX

Toilet Installation Carrollton, TX

Toilet installation in Carrollton is a quick job when the measurements are right, and Flush Hour Plumbing, on Randolph Street, checks them first. The price for removal, setting and hookup comes before the old toilet is unbolted.

  • Price first, work second
  • Tested before we leave
Illustration of a plumber kneeling beside a white toilet and reaching into the open tank, with the lid resting on a towel and a toolbox on the floor

The basics

One number decides which toilets will fit: the rough-in, measured from the bare wall behind the bowl to the middle of the two floor bolts. Most homes measure twelve inches; some older ones come in at ten or fourteen, and a bowl built for one spacing will not sit right on another. Seat height, round versus elongated, and elbow room beside the vanity, tub and door come next.

Setting a toilet properly means checking the flange before the new one goes down. A cracked or low flange is repaired or raised so the seal can do its job, and the toilet is shimmed if the floor is uneven. A new supply line goes on, the bolts are snugged without cracking the porcelain, and the toilet is flushed several times and checked at the tank, the base and the supply.

Good reasons for a new toilet

  • A crack in the bowl or tank, even a hairline one
  • Clogs every week although the drain line is clear
  • An older model that uses three gallons or more per flush
  • Parts that are no longer made for the model
  • A remodel, or a taller seat for comfort

Your route

How the job goes

  1. Measure first

    Rough-in, clearances and the condition of the floor around the old toilet are checked.

  2. Price the swap

    You hear the cost of removal, setting and any flange repair before work starts.

  3. Out with the old

    Water is shut off, the old toilet is drained and lifted, and the flange is cleaned and inspected.

  4. Set, connect, test

    The new toilet goes on a fresh seal, is leveled and connected, and is flushed repeatedly to check for leaks.

Road conditions

The Carrollton angle

Toilets sold in Texas today must use 1.28 gallons or less per flush, so replacing a model from before the mid-1990s can cut that toilet's water use by more than half. In Carrollton's slab homes the flange is set in concrete, and a cracked one is repaired with a ring made for the job rather than by breaking the floor.

Quick answers

Toilet Installation: common questions

What should I measure before buying a toilet?

Hook a tape on the finished wall, not the baseboard, to the center of a bolt cap. Then measure the side clearance and the space in front. Take those numbers to the store, or give them to us when you call.

Is a taller toilet worth it?

Comfort-height bowls sit two or three inches higher than standard and are easier for many adults to use. In a bathroom used mostly by small children, standard height may suit better.

How long does a toilet installation take?

Most swaps are done in one visit of a couple of hours or less. A damaged flange or a soft floor adds time, and you hear about it before that work is done.

How to book toilet installation in Carrollton

Call (972) 734-3086 and tell us the rough-in measurement if you have it, and whether the new toilet is already on site. Any soft spots in the floor around the old one are worth mentioning.

Service area

Toilet Installation near Carrollton

Carrollton is home base. These nearby cities have a page of their own.

Ready to take this exit?

Call and describe what is going on. The price shows up before the work does.

Call now