Carrollton, TX
Sink Installation Carrollton, TX
Sink installation in Carrollton is about the basin and everything below it: the mounting, the drain, the trap and the connections. From Randolph Street, Flush Hour Plumbing checks how the new sink will sit and drain and quotes the job before work starts.
- Price first, work second
- Tested before we leave
The basics
Sinks mount in a few ways, and each needs different work. A drop-in sink rests on the counter with its rim sealed down. An undermount sink hangs from clips or brackets below a stone counter, so its seal and supports carry all the weight. Pedestal, wall-hung and vessel sinks in bathrooms each need their own supports and drain heights. A laundry or utility sink needs a sturdy stand and a drain that can take a washing machine's discharge.
Below the basin, the drain has to line up. A deeper new sink can leave the tailpiece too low for the trap, a double bowl needs the right connections between its halves, and a kitchen sink may also carry a disposal and a dishwasher drain. The trap is fitted or rebuilt to suit, supply lines and valves are checked, and the sink is filled and drained to prove every joint is dry.
Good reasons for a new sink
- A chipped, cracked or stained basin that will not come clean
- A drop-in rim that leaks into the cabinet
- A new counter that needs an undermount or a different size
- Swapping one bowl for two, or two for one large one
- Adding a laundry, utility or bar sink where there was none
Your route
How the job goes
Check the setup
Mounting type, cutout size, drain height and any disposal or dishwasher connection are reviewed.
Price it
You hear the cost of setting the sink and reworking the drain and trap before work begins.
Set and seal
The old sink comes out, the new one is mounted and sealed, and the drain and supplies are connected.
Fill and drain
The basin is filled and emptied, the disposal and dishwasher are run if present, and every joint is checked.
Road conditions
The Carrollton angle
When an older Carrollton kitchen gets a new stone counter, the sink usually changes from drop-in to undermount, and the new basin often sits lower than the old one. The drain line coming out of the wall was set for the old sink, so the trap may need reworking for water to drain properly. Cutting or modifying the counter itself is the fabricator's job; the plumbing that connects to it is ours.
Quick answers
Sink Installation: common questions
Is sink installation different from faucet installation?
Yes. A faucet swap leaves the basin and drain alone. A sink installation sets a new basin, seals it and reworks the drain, trap and connections below to suit it. A new faucet often goes in at the same time.
Can my old faucet go on a new sink?
If its hole pattern matches the new sink or counter and it is in good shape, usually yes. If not, it is a good moment to replace it.
Who cuts the counter for an undermount sink?
The counter fabricator makes the cutout to the sink's template. We set the plumbing after the counter is in place and the sink is mounted.
How to book sink installation in Carrollton
Call (972) 734-3086 and tell us which sink is going in, how it mounts, and whether the counter is new or staying. If a disposal or dishwasher is involved, mention it.
Service area
Sink Installation near Carrollton
Carrollton is home base. These nearby cities have a page of their own.
Ready to take this exit?
Call and describe what is going on. The price shows up before the work does.
