Carrollton, TX
Faucet Installation Carrollton, TX
Faucet installation in Carrollton starts with a check that the new faucet suits the sink before the old one is disconnected. Flush Hour Plumbing, on Randolph Street, quotes the job, including any valve or supply line it needs, before work starts.
- Price first, work second
- Tested before we leave

The basics
Faucets are built for a set number of holes in the sink or counter: one, three, or a wide spread. A single-hole faucet on a three-hole sink needs a deck plate, and a widespread faucet needs the right spacing underneath. A pull-down kitchen faucet also needs clear space below for its hose and counterweight to travel. Sorting this out ahead of time avoids a return trip to the store.
Installation includes the parts nobody sees. New braided supply lines go on, because the old ones are often as old as the faucet. The shut-off valves are tested and replaced if they leak or will not close. The faucet is sealed to the sink, tightened from below, flushed to clear debris from the lines, and run at every setting.
Good reasons for a new faucet
- The old faucet has been repaired more than once
- Parts for it are no longer available
- A crack in the body or a corroded base
- A new counter, new sink or remodel
- A pull-down sprayer, touchless control or filter tap you want
Your route
How the job goes
Check the fit
Hole count, spacing and the space under the sink are compared with the new faucet.
Price it
You hear the cost of the installation, including any new valves or supply lines, before work begins.
Swap and seal
Off comes the old fixture, the sink top is scraped clean of old putty, and the new faucet is seated, sealed and hooked up.
Flush and test
Lines are flushed, the aerator fitted, and every connection checked dry at full pressure.
Road conditions
The Carrollton angle
Many Carrollton kitchens and baths still have their original shut-off valves, some forty or fifty years old in the houses south of Belt Line Road. Those multi-turn valves often drip or seize once they are moved. Changing them while the faucet is out costs far less than a separate visit later, and it means the new faucet can actually be shut off when it needs service.
Quick answers
Faucet Installation: common questions
Will any faucet fit my sink?
No. Count the holes in the sink or counter and measure the spread between the outer ones. A faucet with fewer holes can cover extras with a deck plate; one that needs more holes cannot fit.
Do I need new shut-off valves?
Not always. If they close fully and do not drip, they can stay. If they are old multi-turn valves that are stiff or weeping, replacing them during the installation is worth it.
How long does it take?
A straight swap on an easy-to-reach sink is usually a short visit. Seized nuts, corroded valves or a cramped undermount sink add time, and you hear if that is likely before we start.
How to book faucet installation in Carrollton
Ring (972) 734-3086 and describe the sink, the faucet you have picked or are considering, and the number of holes in the deck. Roughly how old the shut-offs are is useful too.
Service area
Faucet Installation near Carrollton
Carrollton is home base. These nearby cities have a page of their own.
Ready to take this exit?
Call and describe what is going on. The price shows up before the work does.
