Daily 8 AM–8 PM

Carrollton, TX

Faucet Repair Carrollton, TX

Faucet repair in Carrollton comes down, most of the time, to a worn cartridge, washer or O-ring, and Flush Hour Plumbing will tell you plainly when a new faucet is the smarter buy. You get the price from our Randolph Street address before any part is ordered.

  • Price first, work second
  • Tested before we leave
Illustration of a plumber kneeling at an open kitchen sink cabinet and shining a flashlight on the garbage disposal, drain trap and supply lines

The basics

A drip from the spout means the part that stops the water, whether a cartridge, a ceramic disc or a washer and seat, is no longer sealing. Water around the base or handle means an O-ring has worn. Weak flow at one faucet often comes from a clogged aerator or scale inside the cartridge. Each has a cause, and most faucets can be repaired with parts made for that exact model.

The trick is identifying the faucet. Brand, model and cartridge type decide which part fits, and a wrong cartridge leaks or will not turn. The stops below the sink get tested too, because old valves often seize or drip once they are turned. If parts are no longer made, or the body is cracked, you hear the cost of a replacement alongside the repair.

Signs a faucet needs repair

  • A steady drip from the spout with the handle off
  • Water pooling around the base or the handle
  • A handle that grinds, wobbles or will not stay put
  • Hot and cold that no longer mix the way they used to
  • Weak flow at one faucet while the rest are fine

Your route

How the job goes

  1. Identify the faucet

    Brand, model and cartridge type are worked out so the right part is used.

  2. Check the valves

    The shut-offs underneath are tested, since they have to close for the repair and keep working afterward.

  3. Price and repair

    You hear the cost, then the worn cartridge, seal or O-ring is replaced and the aerator cleaned.

  4. Run it hot and cold

    The faucet is run at every setting and checked for drips at the spout, base and supply lines.

Road conditions

The Carrollton angle

Hard water is the main reason faucets fail early in Carrollton. Scale builds on ceramic cartridges and O-rings until they no longer seal or turn smoothly, and it clogs aerators. Soaking an aerator in white vinegar clears much of it. Faucets with plastic internals wear fastest, and some builder-grade models in newer homes are not worth more than one repair.

Quick answers

Faucet Repair: common questions

Is a cheap faucet worth fixing?

If parts are available and the body is sound, one repair often is. If it has needed parts before, or nobody makes them anymore, a new faucet is the better spend.

Why does my faucet drip only on the hot side?

Heat makes worn seals and scaled cartridges swell and misbehave. The cure is the same as for a cold drip: the cartridge or seal on the hot side is replaced.

Can I fix a dripping faucet myself?

Many people can, once they know the model and have the right cartridge. Close the valves under the sink first, plug the drain so small parts cannot vanish, and lay the pieces out in order as they come apart.

How to book faucet repair in Carrollton

Ring (972) 734-3086, say which faucet is acting up and how, and if you can, snap a picture of any logo on it. It also helps to know if the little valves under that sink still turn.

Service area

Faucet Repair near Carrollton

Carrollton is home base. These nearby cities have a page of their own.

Ready to take this exit?

Call and describe what is going on. The price shows up before the work does.

Call now