Flush Hour Plumbing of Carrollton
Water Tank Installation Irving, TX
Water tank installation in Irving is nearly always about the small expansion tank mounted next to a water heater, and the plumber starts by explaining whether your plumbing needs one and why. Reading the house pressure at an outside spigot settles that question, and you hear the price before anything is mounted.
Irving homes and water tank installation
Most expansion tanks in Irving go in when a heater is replaced, and the city requires a water heater permit for that swap even at the old connections. A tank becomes necessary once a pressure-reducing valve, or a backflow check at the meter, seals the plumbing off from the street, leaving heated water nowhere to expand. Houses built around 1974, the median in 75060 and 75062, predate the routine use of these tanks, so a heater swap there is often the first time one is fitted. In Valley Ranch and 75039, a tank may already hang beside the heater, put in with an earlier one, and it is checked rather than assumed good.
the tank's air charge has to match the house's own pressure, so the plumber reads it with a gauge before mounting anything. Irving's water system, with over 735 miles of main, does not deliver the same pressure to every address, so measure first and charge second: a neighbor's number is no guide to yours. An undercharged tank fills with water and stops working; an overcharged one cannot absorb anything. The tank then hangs from a strap or bracket on the cold line, never from the pipe alone.
Some Irving properties water their lawns from private wells, and the city recognizes them: well users, like lawns on DCURD water in parts of Las Colinas, are exempt from the watering schedule as long as a yard sign shows the well is in use, though they still fall under the city's backflow program. A well pump's pressure tank is sized to the pump rather than a heater and charged before it is connected, and the pressure switch is set to suit that charge.
Irving at a glance
- County
- Dallas County (the whole city)
- Typical home
- Median home built in 1986
- Water supply
- Jim Chapman Lake water via Lewisville Lake, treated by Dallas
- Permit office
- Inspections Dept., City Hall 2nd floor, 825 W. Irving Blvd.
- From our office
- About 12 miles from our Randolph St office in Carrollton
Clues that a house is missing an expansion tank
- An occasional drip from the heater's relief pipe
- Pipes knock or faucets spit right after the heater runs
- A gauge on a hose bib reads high after a heating cycle
- A replacement heater on a closed system with no tank yet
- A pressure reducer at the meter and nothing to absorb expansion
Questions from Irving
What pressure should our expansion tank be charged to?
Your house's own static pressure, read with a gauge on an outside faucet while nothing is running, not a citywide figure. If the reading looks wrong in either direction, ask Irving's water utility to look at its meter; the city will check pressure and flow there, which shows whether the street side is the cause. A high reading also deserves a look at the pressure-reducing valve before the tank goes on.
Where can the relief valve line from our heater end?
Irving's amendment to the 2024 IRC wants it to drain by gravity at full pipe size through an air gap, finish no more than six inches above the floor or a receptor, and stay in plain sight of the people living there, with nothing threaded, teed or valved on it. Ending low and visible is the point: a drip anyone can see is often the first sign a house needs an expansion tank.
Where does the tank go?
On the cold line a foot or two from the heater, with a strap or bracket carrying its weight so the pipe is not holding it up. Attic installs keep it over the pan or right next to it. It needs only a small patch of wall.
Booking in Irving
ring (972) 734-3086 and say what the tank will serve. If you have ever put a gauge on a hose bib, the reading helps, and so does a glance at the meter box or the incoming line for a bell-shaped brass valve, which is usually the pressure reducer.
Other services in Irving
- Drain Cleaning
- Hydro Jetting
- Plumbing Leak Detection
- Plumbing Leak Repair
- Plumbing Pipe Repair
- Water Heater Repair
- Water Heater Installation
- Sewer Line Inspection
- Sewer Cleaning
- Sewer Repair
- Emergency Plumbing Service
- Whole Home Repiping
- Gas Line Repair
- Backflow Prevention Testing
- Toilet Repair
- Garbage Disposal Repair
- Toilet Installation
- Faucet Repair
- Garbage Disposal Installation
- Shower Repair
