Daily 8 AM–8 PM

Flush Hour Plumbing of Carrollton

Water Tank Installation Addison, TX

Water tank installation in Addison nearly always means fitting an expansion tank on the water heater's cold line, and the plumber explains why your house needs one before it goes on. The short version: the town's meters stop water from flowing back to the main, so heated water has to expand somewhere else.

Addison homes and water tank installation

every water meter in Addison includes a check valve, and the town's water heater rules follow from it: every tank heater must have a thermal expansion tank, sized to keep the system at or below 80 psi. Without one, the extra volume from each heating cycle has nowhere to go, pressure climbs, and the relief valve, faucet cartridges and supply hoses take the strain. Water heaters are on the town's permit list, replacing or adding, and an installation without the tank does not meet its rules. A pressure gauge screwed onto an outdoor tap shows how close a house is running to that limit.

Backflow rules add a second reason. Addison's cross-connection ordinance, which amended Chapter 82, makes owners responsible for thermal expansion whenever a backflow assembly closes off the system, so a house with an assembly on its supply is closed twice over. New lawn sprinklers in Addison need a town permit and an approved assembly, so any house with a permitted sprinkler system has one. The tank does not care which valve sealed the house. It is sized from the heater's gallons and the home's incoming pressure, so two houses on the same street can need different tanks.

Where the tank goes follows the heater. in the town's houses, built 1978 to 1994, that usually means the garage or the attic. Townhomes and condos more often tuck the heater into a closet off a hallway. Wherever it sits, the tank should be braced to the wall rather than left hanging on the pipe. If you rent, the tank comes with the landlord's water heater, and a dripping relief valve after every shower belongs on a maintenance request, not your to-do list.

Addison at a glance

County
Dallas County
Typical home
Median year built 1998; owner-occupied homes 1994
Water supply
Town-run system; all water bought from the City of Dallas
Permit office
Building Safety, Addison Service Center, 16801 Westgrove Drive
From our office
About 5 miles from our Randolph St office in Carrollton

Clues that a house is missing an expansion tank

  • An occasional drip from the heater's relief pipe
  • Pipes knock or faucets spit right after the heater runs
  • A gauge on a hose bib reads high after a heating cycle
  • A replacement heater on a closed system with no tank yet
  • A pressure reducer at the meter and nothing to absorb expansion

Questions from Addison

We have a tankless heater. Do we still need an expansion tank?

Maybe not. Addison's rule is aimed at tank heaters, which store and heat a large volume at once, while a tankless unit holds very little water, so thermal expansion is far smaller. The meter's check valve still seals the house, though, so the plumber checks the pressure at an outdoor tap first. If the pressure barely moves through a heating cycle, a tank adds nothing, and you hear that.

Does a condo or townhome need its own expansion tank?

If it has its own tank water heater, it needs the same protection as a house. Every Addison meter has a check valve, and whether a heater serves one unit or a whole building, the expansion from heating has to go somewhere. In a building with a central water heating system, that equipment is the association's. If your unit's heater is yours, the tank beside it is too.

Where does the tank go?

On the cold line a foot or two from the heater, with a strap or bracket carrying its weight so the pipe is not holding it up. Attic installs keep it over the pan or right next to it. It needs only a small patch of wall.

Booking in Addison

Ring (972) 734-3086 and say what the tank will serve. If you have ever put a gauge on a hose bib, the reading helps, and so does a glance at the meter box or the incoming line for a bell-shaped brass valve, which is usually the pressure reducer.

Water Tank Installation in other cities

Ready to get things moving again?

Call now