Carrollton, TX
Water Tank Installation Carrollton, TX
Water tank installation in Carrollton almost always means the small expansion tank that sits beside a water heater. Flush Hour Plumbing, on Randolph Street and open seven days a week, will tell you if your house actually needs one, and why, before you pay for it.
- Price first, work second
- Tested before we leave
The basics
Heat a tank of water and it swells. Where nothing blocks the way, that extra volume simply nudges back out toward the street. Fit a pressure reducer or a one-way valve at the meter, as many homes have, and the way back is shut, so the pressure inside the pipes jumps every time the heater fires. The fix is a small steel vessel, not much bigger than a basketball, split inside by a rubber diaphragm with air on one side, plumbed onto the cold supply beside the heater.
A well's pressure tank is a different animal: it holds a reserve under pressure so the pump can rest between uses instead of firing for every glass of water. You will rarely find one inside Carrollton, where homes run on city water, though rural lots farther out still use them. With either type, the air side has to be pumped up to suit the home's pressure before installation, a step that gets skipped far too often.
Clues that a house is missing an expansion tank
- An occasional drip from the heater's relief pipe
- Pipes knock or faucets spit right after the heater runs
- A gauge on a hose bib reads high after a heating cycle
- A replacement heater on a closed system with no tank yet
- A pressure reducer at the meter and nothing to absorb expansion
Your route
How the job goes
Measure the pressure
A gauge threaded onto a hose bib reads the static pressure, then is watched while the heater fires to see how far it rises.
Pick the size
Its size comes from how many gallons the heater holds and the pressure in the house; a well tank is matched to the pump instead.
Charge and mount
The air side is pumped to the house pressure with a gauge, then the tank is braced and connected with its own shut-off.
Watch it work
With the heater running, the gauge needle should barely move, and you can watch it hold.
Road conditions
The Carrollton angle
Expansion tanks show up in a lot of Carrollton garages and attics for one reason: many houses here have a pressure reducer on the incoming line, and once that is in place the plumbing is sealed off from the street. A tank installed without setting its air charge can fail early. Well and storage tanks are rare inside the city; if yours serves something unusual, such as a rainwater system or a property outside town, tell us what it feeds when you call.
Quick answers
Water Tank Installation: common questions
Is an expansion tank required with every heater?
No, only in a house whose plumbing is sealed off from the street, typically by a pressure reducer or a one-way check at the meter. That gets checked whenever a heater is swapped, and you are told the answer either way.
Where does the tank go?
On the cold line a foot or two from the heater, with a strap or bracket carrying its weight so the pipe is not holding it up. Attic installs keep it over the pan or right next to it. It needs only a small patch of wall.
What air pressure should it have?
It should equal the home's water pressure. The plumber pumps it up or bleeds it down to that number with a tire gauge before mounting, since the factory charge seldom fits.
How to book water tank installation in Carrollton
Ring (972) 734-3086 and say what the tank will serve. If you have ever put a gauge on a hose bib, the reading helps, and so does a glance at the meter box or the incoming line for a bell-shaped brass valve, which is usually the pressure reducer.
Service area
Water Tank Installation near Carrollton
Carrollton is home base. These nearby cities have a page of their own.
Ready to take this exit?
Call and describe what is going on. The price shows up before the work does.
