Carrollton, TX
Shower Installation Carrollton, TX
Shower installation in Carrollton, on the plumbing side, means the valve, the supply lines, the drain and the head, all set at the right heights before tile goes up. Flush Hour Plumbing, on Randolph Street, prices that work before it begins.
- Price first, work second
- Tested before we leave
The basics
A shower is mostly hidden plumbing. The valve sits in the wall at a height and depth that has to match the tile and trim that come later. Supply lines run to it, a pipe runs up to the head, and the drain below has to land in the right spot for the pan or base. Getting those right before the walls close is what makes the finished shower work and look straight.
Tub-to-shower conversions are common: the drain is adapted to suit a shower base, the valve is changed to a single-handle pressure-balancing type, and the head is raised. Walk-in and curbless showers need the drain lowered or a linear drain fitted, which on a slab means cutting concrete. The trim you have chosen is checked against the valve, since many trims fit only their own brand's valve.
When a new shower valve or layout makes sense
- Walls already opened for a bathroom remodel
- Replacing a tub with a walk-in shower
- An old two- or three-handle valve with worn parts
- Wanting a hand shower, body sprays or a taller head
- A leak behind the wall from the old valve body
Your route
How the job goes
Plan the layout
Valve height, head height, drain position and fixtures are agreed before any rough-in.
Price the plumbing
You hear the cost of the valve, lines and drain work before it begins.
Rough in
Valve, supply lines and drain are installed and pressure-tested while the walls are open.
Finish and test
After tile, the trim and head are fitted, the hot limit is set, and the shower is run and checked.
Road conditions
The Carrollton angle
Because Carrollton bathrooms are built on concrete, relocating a shower drain means cutting and patching the slab, and in a post-tensioned slab the cables have to be located first. Keeping the drain where it is saves money; moving it is still possible when the design calls for it. An upstairs shower in a two-story home gets a properly sloped pan and a flood test before tile, since a leak there shows up in the ceiling below.
Quick answers
Shower Installation: common questions
Can a tub become a walk-in shower?
Usually. The drain is adapted to the shower base, the valve is changed or moved, and the head is raised. Most of the plumbing happens in one stage while the walls are open.
Do I need a new valve for a new shower trim?
Often. Many trims fit only their own brand's valve, so check before buying. Replacing the valve while the wall is open is far simpler than doing it later.
Who does the tile and glass?
Usually your remodeler or tile setter. The plumbing is roughed in first, tested, and finished after the tile is done.
How to book shower installation in Carrollton
Ring (972) 734-3086 and say what the project is, a remodel, a tub-to-shower change or a valve swap, and how far along it is. Model names for any valve and trim already picked are a help.
Service area
Shower Installation near Carrollton
Carrollton is home base. These nearby cities have a page of their own.
Ready to take this exit?
Call and describe what is going on. The price shows up before the work does.
