Daily 8 AM–8 PM

Carrollton, TX

Bathtub Installation Carrollton, TX

Bathtub installation in Carrollton is as much about getting the old tub out as getting the new one in. Flush Hour Plumbing, on Randolph Street, checks the size, the drain and the route through the house and quotes the job before anything is removed.

  • Price first, work second
  • Tested before we leave

The basics

Standard alcove tubs are about five feet long, but drain side, depth and width vary, and the new tub has to match the drain position or the drain has to move. Freestanding tubs need a floor drain in the right place and a floor-mounted or wall-mounted filler. Cast iron tubs are heavy enough that the route through the house, and the floor under the tub, need a look before delivery.

The plumbing side covers the drain and overflow, the connection to the trap under the floor, the valve and spout, and a leak test before the tub is enclosed. On a slab the trap sits in an opening in the concrete under the drain, and moving it means cutting the slab. The tub is set level on a bed or supports that keep it from flexing, so the caulk and grout around it hold.

Good reasons for a new tub

  • A cracked tub that leaks or flexes underfoot
  • A worn finish that will not come clean
  • Wanting a deep soaker, or a tub that stands on its own
  • A remodel that changes the bathroom layout
  • An old valve and spout that should be replaced with it

Your route

How the job goes

  1. Measure and check

    Tub size, drain side, floor condition and the route in and out are checked.

  2. Price it

    You hear the cost of removal, setting and connections, and any drain changes, before work begins.

  3. Remove and set

    The old tub is pulled, the drain is readied, and the replacement is leveled and fastened in place.

  4. Connect and test

    Drain, overflow and valve are connected, the tub is filled and drained, and every joint is checked.

Road conditions

The Carrollton angle

With most Carrollton tubs on a slab, the trap and drain below are only exposed when the tub comes out, so a replacement is the time to inspect them and replace any that are corroded. Older homes south of Belt Line Road may still have original steel or cast iron tubs and drain fittings; newer homes mostly have acrylic or fiberglass tubs, which are lighter to remove.

Quick answers

Bathtub Installation: common questions

Can a tub be replaced without redoing the tile?

Sometimes, with an alcove tub that comes out cleanly and a new one of the same size. Often the bottom row of tile has to come off. You hear what is likely before work starts.

Will a freestanding tub work in my bathroom?

It needs a drain in the right spot, usually in the slab, and a filler. Moving a drain on a slab is possible but adds work.

How heavy is a cast iron tub?

Often three hundred pounds or more when empty. That affects how it is carried in and, upstairs, what the floor needs.

How to book bathtub installation in Carrollton

Call (972) 734-3086 and tell us the tub you have, the tub you want and whether the bathroom is on the ground floor. The tile around it matters too, so describe that.

Service area

Bathtub Installation near Carrollton

Carrollton is home base. These nearby cities have a page of their own.

Ready to take this exit?

Call and describe what is going on. The price shows up before the work does.

Call now