Daily 8 AM–8 PM

Flush Hour Plumbing of Carrollton

Backflow Prevention Testing Coppell, TX

Backflow prevention testing in Coppell is a yearly duty for any home with a sprinkler system, and the rules behind it sit in the city's plumbing code. You hear which assembly is due, what the test measures and what a failure would mean before any gauge is connected.

Coppell homes and backflow prevention testing

Coppell's amendments to the plumbing code make the property owner responsible for every backflow assembly on the lot and set the timetable: a test at installation, again immediately after any repair or relocation, and at least annually after that. Residential irrigation systems must have one, and so must boilers and fire sprinkler systems. Test reports go to SC Tracking Solutions, the service the city uses to collect them. The duty stays with the property, so a buyer should ask the seller for the most recent report along with the keys.

On a typical lot, the assembly in question is the double check valve on the sprinkler line. The city's irrigation handout puts it within 5 feet of where the system taps the supply line, before any other connection, in a box set level with the ground over two inches of pea gravel, with six inches of clearance around it. Altering that tap or the backflow device takes an irrigation permit, so swapping the assembly is permitted work. A new automatic system also needs rain or moisture and freeze sensors, which keep it from watering through a storm or onto a frozen lawn.

A hard freeze can crack an above-ground assembly's body, and a cracked one is replaced rather than rebuilt; worn springs and rubber parts are rebuilt and the device is tested again. Separately, the city's Sprinkler Evaluation Program, paid for from its water and sewer fund, sends an irrigator to look over controllers and schedules. It is a checkup, not a backflow test, and it makes no repairs; new slots open on the 25th of each month. If your 75019 address is in Cypress Waters or South Haven, Dallas or Irving supplies the water and sets the rules.

Coppell at a glance

County
Dallas County (small part in Denton County)
Typical home
Median year built 1994
Water supply
Treated water bought from Dallas Water Utilities (DWU)
Permit office
Building Inspections, 265 E. Parkway Blvd., Coppell 75019
From our office
About 7 miles from our Randolph St office in Carrollton

When a backflow test is due

  • A notice from your water utility asking for a test
  • A sprinkler system that is new or just repaired
  • Water dripping from the relief port on the assembly
  • A device cracked or damaged by a freeze
  • Buying or selling a house with an irrigation system

Questions from Coppell

Is the box with the green lid near my meter mine or the city's?

Yours. Coppell's water FAQ says the green plastic lid near the meter covers the irrigation double-check, and that it is the homeowner's responsibility. The meter beside it belongs to the city, locked lid and all. If the green box is buried or cracked, clearing and repairing it makes the yearly test easier and protects the assembly inside.

Does getting the assembly tested change my watering days?

No. The test checks the assembly, and your schedule stays the city's. From May 1 through Sept. 30, Coppell's Stage 1 rules limit sprinklers to two days a week: even-numbered addresses on Tuesdays and Saturdays, odd-numbered ones on Wednesdays and Sundays. Hand watering, drip lines and soaker hoses are allowed on any day.

Why do I need a backflow test?

To show that the device protecting the public water supply still works. Utilities ask for a test when an assembly is installed and on a schedule they set, most often for irrigation systems.

Booking in Coppell

Ring (972) 734-3086 and read us the notice from your water utility, or explain why you want the assembly checked. Its location and what it protects are the next questions.

Backflow Prevention Testing in other cities

Ready to get things moving again?

Call now