Daily 8 AM–8 PM

Carrollton, TX

Whole Home Repiping Carrollton, TX

Whole home repiping in Carrollton is the fix for houses that keep springing leaks in the same tired pipe. Flush Hour Plumbing, based on Randolph Street, lays out the route, the material and one full price before a single wall is opened.

  • Price first, work second
  • Tested before we leave

The basics

Repiping replaces the supply lines, the pipes that carry water under pressure to every fixture, and leaves the drains alone unless they need work too. It is the answer when the existing pipe is failing as a material: polybutylene letting go at its fittings, galvanized steel rusting shut from inside, or copper that has started to pinhole in more than one place.

On a slab, the new piping normally travels overhead, across the attic, and comes down inside each wall to the fixture it feeds, which lets the old under-floor lines be left in place and forgotten. PEX gets used most because it curves past studs and needs few fittings, though copper remains a choice. Drywall cuts stay small, the house loses water only during each tie-in, and each run is pressure-tested before any wall is patched.

Signs the pipes have reached the end

  • Gray plastic supply pipe stamped PB
  • A third leak in as many years
  • Rusty or brown water when a tap first opens
  • Pressure that has faded throughout the house
  • A second slab leak on lines that already leaked once

Your route

How the job goes

  1. Plan the route

    The plumber traces a path for new lines from the attic down to each fixture and the water heater.

  2. One price for the whole job

    You get the price for the repipe, including openings and connections, before anything is ordered.

  3. Run and connect

    New lines go in section by section, and each fixture is connected and tested before moving on.

  4. Test the whole system

    The finished system is pressurized and watched, each tap and toilet is run, and every room worked in is cleaned up.

Road conditions

The Carrollton angle

The middle of Carrollton is full of homes put up in the 1980s and early 90s, the years when polybutylene was widely installed across North Texas. Older homes south of Belt Line Road may still carry galvanized steel or early copper. In a single-story slab home, running new lines overhead through the attic is usually simpler than it sounds, and it takes the water pipes out of the shifting clay for good.

Quick answers

Whole Home Repiping: common questions

Will we have to move out?

Usually not. Water is shut off while sections are connected and restored at the end of each working day where the job allows. You hear the schedule before work begins.

How do I know if I have polybutylene?

Check where the supply comes into the house, the pipes on top of the water heater, and under the sinks. Polybutylene is gray, sometimes blue outdoors, and is often stamped PB. Copper, or white and red PEX, means something else is in there.

PEX or copper?

PEX is flexible, needs fewer joints and copes well with hard water and freezing. Copper also lasts well and costs more to install. Either is sound when it is put in properly.

How to book whole home repiping in Carrollton

Ring (972) 734-3086 with the year the house was built, a description of the pipe, and the number of leaks so far. Bathroom count and where the water heater sits help schedule the walk-through that maps the new route.

Service area

Whole Home Repiping near Carrollton

Carrollton is home base. These nearby cities have a page of their own.

Ready to take this exit?

Call and describe what is going on. The price shows up before the work does.

Call now